Etelux Glove Box Regeneration Ways

From Ken's Dashboard Project
Jump to: navigation, search

1) Regeneration fuel: a mixture of hydrogen and inert fuel (hydrogen accounts for five% -ten%)

two) Amount: 40L gas cylinder 10Mpa

3) Regenerative fuel pressure: .05Mpa (the gasoline intake per 50 % hour in the condition of .05Mpa is that the cylinder force drops by 1.5Mpa. If it exceeds 1.5Mpa, the stress of the pressure regulator’s program will be lowered, if it is less than 1.5Mpa Maximize the tension of the tension regulator program)

4) Procedure: three several hours heating-three several hours heating and air flow-three hrs vacuuming-1 hour pumping-10 several hours cooling

five) Ways:

① Join the regeneration gasoline (examine the pipeline for leaks just after relationship: Hundred Class Purification Glove Box following connecting, open up the key valve of the stress reducing valve to the highest, open the auxiliary meter to .1Mpa, switch off the most important valve, hold out fifteen minutes, if the stress of the auxiliary meter stays at .1 Mpa remains unchanged, indicating no air leakage

>②Set the stress of the auxiliary gauge of the strain minimizing valve to .1Mpa (the stress throughout air flow is about .06-.08MPa

>③ Close the cycle and analyz

r>④Turn on the vacuum pu

r>⑤ Get started regenerat

br>⑥ The new program finishes at 20h (cleanse ahead of cleansing, drinking water and oxygen index <200p


6) Note: Do not cut off the power and gas during the regeneration process (especially the first 6 hours)! Some pressure reducing valves are not allowed, and the pressure needs to be adjusted appropriately to ensure continuous ventilation for 3 ho


7) Observation: whether the regeneration gas flowmeter shows about 20L / min, otherwise adjust the pressure of the pressure reducing valve.